It is very uncomfortable for a long duration. This is in addition to my Stax SR-001 headset, which I don't listen to much anymore. I have the QC2, TriPort IE (for my iPod) and Companion 3 computer speakers. I've been meaning to learn to solder anyway.Posted on Tuesday, Febru18:10 GMTNuck, Bose has treated me well in the past. I'm not selling the whole system because the surround sound is already wired with cables running through the walls and whatnot- and i don't want to do that again.worst case scenario, i can just solder a new RCA plug on the end and go back to debating the cost of a complete new system. If that's the case, then i would have to replace the subwoofer but not the other speakers right? Since the digital output would go through the bose link cable to the subwoofer, get processed and then sent out as analog to the speakers.if i'm stuck with it i'm stuck with it, but it's worth trying. Once you hack the cables it starts getting harder to sell them for their value and I'd bet you'll be disappointed in the sound quality without the Bose signal processing. You might be better off selling the system complete and buying speakers designed to be run from a normal amp. I'm pretty sure that Bose speakers have quite a bit of signal processing going on due to their unique designs. Copper is copper, so this should work at least in theory, no?and if this is true, then the same should be possible of the sub and its bose link connector. Is this possible? The negative of the speaker wire should be connected to the outer ring part of the RCA plug, and the positive should be connected to the center pin, so it should be pretty easy to remove the plugs and label the wire + and - myself and run that to the new receiver. Each speaker is wired to the subwoofer through a two-wire cable that ends in a generic RCA plug which plugs into the subwoofer, and then their signals go through the proprietary bose cable to the receiver.what i want to do is hack off those RCA plugs and then plug the speaker wire directly into a new receiver. It's actually just a Mini DIN 9-pin connector, with a nonstandard pinout and a $60 pricetag. The problem is since they've bought into the bose ecosystem, everything is proprietary.the receiver connects to the subwoofer - and only the subwoofer, it doesn't connect to the speakers directly - by a proprietary 'Bose Link' cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |